Kodak Alaris Inc.
WIA Debugging Instructions
11-November-2013
1.
Overview
2.
Configuring
3.
Creating file to send to Kodak Alaris
Inc.
The following
describes how to enable and find debug information for the WIA driver.
NOTE: It is suggested that you only generate
debug information when instructed by Kodak Alaris
Inc. support personnel.
Turning on debug information depends on the version
of the WIA driver (see WIA Versions in the
readme for more information on determining the WIA version). To turn on debug
information, you will copy one or more files that are provided for you (they
are in the same directory in the Integrator's Guide as this file). The location
of where to copy the file(s) to is within the scanner’s model directory (see Finding the scanner’s model directory
in the readme).
For all wia.dll
drivers and for 4.x wiamini.dll drivers:
1.
Copy
const.ini to the wia folder
(e.g. C:\Documents and Settings\All Users\Application Data\kds_kodak\kds_i4200_i4600\wia)
2. 2Power cycle the scanner
For 2.1 and 3.x wiamini.dll WIA drivers:
3.
Copy
wia.ini to the wia folder (e.g.
C:\Documents and Settings\All Users\Application Data\kds_kodak\kds_i1200\wia)
4.
Copy
wiamini.ini to the wiamini
folder (e.g. C:\Documents and Settings\All Users\Application Data\kds_kodak\kds_i1200\wiamini)
5. Power cycle the scanner
The debug information is stored in the same
location as the TWAIN debug information. So use the TWAIN UI to create an .eklog file; which can be done via SVT:
1.
Start
SVT
2.
Click
the Setup button (left most button on toolbar), to bring up the TWAIN UI
3.
Go
to the Logs tab (click Settings, then click Device, then click Diagnostics,
then click Logs)
4.
Click
Save As button (on toolbar in upper-right corner of the tab)
5.
Select
a folder and click Save